3-20 User’s Guide3.5.1 Power Management ModeThis parameter allows you to reduce power consumption. When thisparameter is set to Enabled, you can configure the system timers.Setting to Disabled deactivates the power management feature andall the timers.For system models with RDM moduleinstalled, enabling the RDM feature disablesthe power management parameters.IDE Hard Disk Standby TimerThis parameter allows the hard disk to enter standby mode afterinactivity of 1 to 15 minutes, depending on your setting. When youaccess the hard disk again, allow 3 to 5 seconds (depending on thehard disk) for the disk to return to the normal speed. Set thisparameter to Off if your hard disk does not support this function.System Standby TimerThis parameter sets the system to a "fast-on" power saving mode. Itautomatically enters the standby mode after a specified period ofinactivity. Any keyboard or mouse action, or any enabled monitoredactivities occurring through IRQ channels, resume system operation.See section 2.5.2.System Suspend TimerThis parameter sets the system to a "fast-on" power saving mode. Itautomatically enters the standby mode after a specified period ofinactivity. Any keyboard or mouse action, or any enabled monitoredactivities occurring through the IRQ channels, resume systemoperation. See section 2.5.2.
