Setup 6-136.4.8 PasswordsTwo passwords are implemented in this notebook. The Setup Passwordprevents unauthorized access to the BIOS Utility, while the Power OnPassword prevents unauthorized access to the notebook during boot-up andresume from hibernation.Setting a PasswordTo set a password, select the desired password (Setup and Power On) toset or edit, and press ←← or →→. The password prompt (a key) appears:A message below the menu prompts you to enter a password. Thepassword may consist of up to seven characters which do not appear on thescreen when you type them. After typing your password, press Enter.Another prompt appears asking you to retype your password to verify yourfirst entry.After setting a password, the notebook sets this parameter to [Enabled].The next time you boot the notebook, resume from hibernation mode or runthe BIOS Utility, the password prompt appears. Key in the appropriatepassword (Power On or Setup). If the password you entered is incorrect, an“X” appears. You have three chances to type in the correct password. Afterthree tries, the following message appears:Incorrect password specified. System disabled.The notebook freezes up and disables all devices. You must turn off thenotebook and turn it on again to retry. If you forget your password, youmust reset the configuration values stored in CMOS to defaults. ResettingCMOS requires opening up the notebook, so contact your dealer forassistance.
