6-6 User’s Manual6.3.3 Hard Disk DriveThe default setting for Hard Disk is [Auto]. With this setting, the BIOSautomatically detects your drive parameters. You can also opt to key inyour drive parameters by setting this parameter to [User]. To determineyour drive parameters, look at the data on the label pasted on your harddisk drive (or supplied in vendor documentation) and type in theparameters. Be sure to set the correct drive parameters; otherwise an errormessage appears when you boot up the notebook. We suggest you set thisparameter to [Auto].6.3.4 Large Hard Disk CapacityThe default setting for Large Hard Disk Capacity is [Enabled]. Set thisparameter to [Disabled] if you use a non-DOS or non-Windows-basedoperating system on this computer.6.3.5 Memory TestThe notebook can test main memory for errors when you turn it on. Thedefault setting, [Disabled], allows the notebook to bypass the memorytest and speed up the self-test procedure.6.3.6 Boot DisplayIf you connect an external monitor, you can switch display between the LCDand the external display. This parameter determines which display devicethe notebook uses on boot-up. Table 6-1 describes the different settings.If notebook resolution is set at 640x480, the image on thenotebook and external monitor will not be full-screen. For full-screen image, set-up notebook at 800x600 resolution.
