Chapter 2 47Removing a PasswordFollow these steps:1. Use the w and y keys to highlight the Set Supervisor Password parameter and press the e key. The SetPassword box appears:2. Type the current password in the Enter Current Password field and press e.3. Press e twice without typing anything in the Enter New Password and Confirm New Password fields. Thecomputer then sets the Supervisor Password parameter to “Clear”.4. When you have changed the settings, press u to save the changes and exit the BIOS Setup Utility.Changing a Password1. Use the w and y keys to highlight the Set Supervisor Password parameter and press the e key. The SetPassword box appears:2. Type the current password in the Enter Current Password field and press e.3. Type a password in the Enter New Password field. Retype the password in the Confirm New Passwordfield.4. Press e. After setting the password, the computer sets the User Password parameter to “Set”.5. If desired, you can enable the Password on boot parameter.6. When you are done, press u to save the changes and exit the BIOS Setup Utility.If the verification is OK, the screen will display as following.The password setting is complete after the user presses u.
