Altos R520 Installation Configuration Guide 10required.Device Version EasyBUILD VersionIntegrated SAShardware RAID 2 2.20.0.64 EasyBUILD 8.0 build 200 (or later)Onboard Chipset 8.6.0.1002 EasyBUILD 8.0 build 200 (or later)Onboard GigabitEthernet 9.12.17.0 EasyBUILD 8.0 build 200 (or later)Onboard VGA 8.240.50.3000 EasyBUILD 8.0 build 200 (or later)Onboard USB 2.0 N/A OS built-inIOAT 1.2.79.9 EasyBUILD 8.0 build 200 (or later)Hot-swapbackplane N/A OS built-inSoftware RequiredThe management utility of integrated SAS hardware RAID 2 and NIC can befound in the EasyBUILD.Software Version EasyBUILD VersionRAID Web Console2 2.63 EasyBUILD 8.0 build 200 (or later)Intel PROSet Utility 13.0.44.0 EasyBUILD 8.0 build 200 (or later)Configuring integrated SAS hardware RAID 2Please refer to the APPENDIX D. for the integrated SAS hardware RAID 2configuration.Installation TipsNOTE. The Windows Server 2008 x64 can recognize integrated SAS hardwareRAID 2. Please replace the driver with the one provided by EasyBUILD. Youneed an external USB floppy drive or USB Flash drive to load driver during theOS installation.1. Please make a driver diskette from the EasyBUILD first before theinstallation.2. Click on “Load Driver” when “Where do you want to install Windows”message displayed.3. Select “Intel(R) RAID Controller SROMBSASMP2 (A:\oemsetup.inf)” astarget driver4. After loading the RAID driver from diskette, you could click “Driveoptions” to partition the drive.5. Follow the normal procedure to finish the installation.6. After the installation completes, you would see the following deviceswith yellow mark in Device Manager.
