Altos R520 Installation Configuration Guide 108Red Hat Enterprise Linux 4.0 Update 3 Installation (withintegrated SAS SW RAID)Below information describes how to manually install Red Hat Enterprise Linux4.0 Update 3 on Altos R520 with integrated SAS SW RAID.Drivers RequiredFor Red Hat Enterprise Linux 4.0 Update 3 Installation, the following devicedrivers are required.Device Version EasyBUILD VersionIntegrated SAS SWRAID06.06.0728.2006 EasyBUILD 7.1 build 400 (or later)Onboard Chipset N/A OS built-inOnboard GigabitEthernet 7.0.38-NAPI EasyBUILD 7.1 build 400 (or later)Onboard VGA N/A OS built-inOnboard USB 2.0 N/A OS built-inSoftware RequiredThe management utility of integrated SAS SW RAID can be found in theEasyBUILD.Software Version EasyBUILD VersionRAID Web Console2 1.13-07 EasyBUILD 7.1 build 400 (or later)Configuring integrated SAS SW RAIDPlease refer to the Appendix B. for the integrated SAS SW RAID configuration.Installation TipsNOTE. There is no built-in driver Integrated SAS SW RAID in the Red HatEnterprise Linux 4.0 Update2. You need an external USB floppy drive to loaddriver during the OS installation.1. Since Red Hat Enterprise Linux 4.0 Update2 cannot recognize theintegrated SAS SW RAID, you need to make a driver diskette from theEasyBUILD first before the installation.2. Type linux dd when the prompt boot: appears at the start.3. Please select the sda as the Driver Disk Source.4. Follow the instruction to load the integrated SAS SW RAID driver fromthe driver diskette.5. At the Package Installation Defaults, select Customize software packagesto be installed.6. At the Package Group Selection step, select Development Tools under
