OneStart

Menu

Accufast P4 User Manual And Operating Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Page 28 preview
Page 29 preview
Page 30 preview
Contents
  1. Table Of Contents
  2. Introduction
  3. Operating Manual Safety Terms
  4. Power Connection and Fusing
  5. Specifications and Requirements
  6. Unpack and Setup
  7. Mechanical Operation
  8. Lining up the Print on the Piece
  9. Controls, Adjustments and Indicators
  10. Loading Ink
  11. Feeding Pieces
  12. Feed Adjustments
  13. Software and Printing
  14. Piece Design and Layout
  15. printing a document
  16. Printer Controls
  17. Advanced Set Up
  18. Stop Printing
  19. Maintenance
  20. Pen Capping and Storage
  21. Cleaning
  22. Trouble Shooting
Accufast P4 User Manual And Operating Manual Manual pdf 7 page image
73. Unpack and Set UpClear a work space on a flat table and inspect all cartons for obviousshipping damage.NoteReport any signs of shipping damage to the carrier immediately.Open the Printer carton and remove the printer and accessory box.Belt TrackingAdjustmentScrewFeederMountingslotsEncoderShippingKnobThe input end of the P4 ispictured at right. Removethe Encoder Shipping Knobfirst. This knob holds thespring loaded encoderwheel away from the trans-port belt in shipping. Themachine will not print withthis knob in place.Open and remove the feeder. Typically, the small card feeder is the mostused and should be installed first. Both small and large (Fx) feeders willbe covered in this manual. If other feeders are used, their operation willbe covered in a separate annual and they will derive power from a differ-ent source.Remove shipping materials from the printer. In addition to the knob,there are several bits of foam and packing material under the cover, be-tween the cover and the belt and ink jet pen stalls.Re-inspect for shipping damage that may have been hidden from outsidethe carton.
/ 30
This manual is suitable for:
P4
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved