Abus TVVR45030 User Manual

Also see for TVVR35011: User guide User manual

Abus TVVR45030 User Manual Manual pdf 38 page image

Live view117SettingsNoteThe live view can be set as follows.Open the main menu, then click on “Configuration”. Thenclick on “Liveview”:The following settings are available in the TAB “General”:Video Output In-terfaceVGA/HDMI, Main CVBSSelect the connection where the set-tings are changedLive View Mode Different camera layoutsDwell Time Switching time between the individ-ual cameras and the sequence dis-playEnable AudioOutputActivate/deactivate audio output ofthe video output The audio signal isonly given if the corresponding cam-era input is presented as a fullscreen.Event Output Allocate monitor for the output ofeventsFull Screen Moni-toring Durationin seconds, where the event on theallocated monitor will be displayed.Post Event Dis-play Timein seconds, the duration of the Pop-up window when an event occurs.NoteThe recorder image can either be shown on anHDMI or a VGA monitor. The combination of HDMIand VGA output is supported.The BNC output can be used either for a spotmonitor or a separate monitor.NoteVGA monitor connected:A connected HDMI/VGA monitor automaticallybecomes the main monitor where the audio outputis also assigned. The BNC output Video Spot Outoutput displays the cameras in sequence and infull screen.If during the boot process of the DVR the HDMI/ VGA cable isnot connected, the main video signal is displayed at BNC out-put MAIN. Connect the HDMI/VGA cable and reboot the DVRin order to display the main video signal at the VGA output.No HDMI/VGA monitor connected:The main video signal is displayed at BNC outputMAIN. The BNC output Video Spot Out outputdisplays the cameras in sequence and in fullscreen.Setting the camera outputYou can display a maximum of 16 cameras(TVVR45030) in the live cast at the same time.1. Click on the TAB “View”.2. Select the display mode. 1 x 1 2 x 2 3 x 3 1 + 5 1 + 7 4 x 43. The camera signal is assigned to the correspondingimage section using the navigation keys. “X” means that this camera is not displayed.4. Click on Apply to accept the settings.