Abus TVVR40000 User Manual

Abus TVVR40000 User Manual Manual pdf 35 page image

Manual AlarmNoteThe menu is used to check the recording settingsin the event of an alarm, to trigger alarm outputsmanually and to test the settings. You can thencheck and correct your settings in the playbackscreen.1. Select the camera by clicking the corresponding line.2. Click on Trigger to switch on the alarm manually.Trigger then changes to No for this camera.3. Confirm the prompt by pressing OK.4. When Trigger All is selected, then all alarms areswitched on manually.5. Click on Clear All to switch off all alarms simultanously.The menu is used to check the recording settingsin the event of an alarm, to trigger alarm outputsmanually and to test the settings. You can thencheck and correct your settings in the playbackSelect the camera by clicking the corresponding line.on the alarm manually.for this camera.is selected, then all alarms areto switch off all alarms simultane-HDDsNoteThe device manages up todisk drives.Each of the installed HDDs must be initialised bfore the device can be used forvice only detects the HDD and its assignment ater initialisation has been made.WarningAll data is deleted from the HDD during initialistion.Ensure a data backup has been made in goodtime beforehand.Installing the HDD1. Disconnect the device from the mains power andopen the cover.2. Observe the applicable ESD guidelines when hadling electronic devices and ensure they are earthed.3. Do not open the device in rooms with carpets orother surfaces that can becomecharged.4. Avoid bodily contact with all components on thePCB.WarningIf you have questions regarding the information orcannot find the information you need, please cotact your maintenance specialist.5. Install the HDD and then connect it.6. Reattach the cover and connect thmains power supply.7. Switch on the device and start the HDD menu.Device menu35up to four 3.5" SATA hardEach of the installed HDDs must be initialised be-fore the device can be used for recording. The de-vice only detects the HDD and its assignment af-ter initialisation has been made.All data is deleted from the HDD during initialisa-Ensure a data backup has been made in goodDisconnect the device from the mains power andObserve the applicable ESD guidelines when han-dling electronic devices and ensure they are earthed.Do not open the device in rooms with carpets orother surfaces that can become electro staticallyAvoid bodily contact with all components on thetions regarding the information orcannot find the information you need, please con-tact your maintenance specialist.connect it.Reattach the cover and connect the device to theSwitch on the device and start the HDD menu.