AMT/PTD/TR/0001/3/7/EN Installation Manual for digital sets - IP sets - SIP setsPage 9-68 05/2008 SIP PHONES 51i, 53i, 55i AND 57i9.15.1 OperationThe SIP phone is registered on each iPBX: number 3010 on iPBX1, number 5000 on iPBX2.The numbers 3010 and 5000 must correspond to the same subscriber name. Subscriber 5000must be unlisted. Each SIP subscription requires an IP phone licence.When a number is dialled on the SIP phone from the numeric keypad, the ‘main’ line L1 isautomatically used, the number presented on the remote phone is the ‘main’ number (3010).When the ‘secondary’ line L2 is used, it is the ‘secondary’ number (5000) that is presented on theremote phone.In both cases, if a directory record exists, it is the subscriber’s name that will be displayed.In case of incident on SIP access point 1 or on iPBX1:• The STT reroutes calls for phone 3010 to phone 5000: the call is presented on the phone online L2.• Calls leaving the SIP phone must use line L2.• If a number is dialled from the numeric keypad or line L1 of the SIP phone, you obtain ‘Callfailed'.9.15.2 Configuring the SIP phoneThe following instructions must be integrated into the phone’s specific parameters file (@MAC.cfg):#...#...#sip screen name: "Poste 3010" # Name displayed#sip user name: 3010 # NeXspan subscriber number#sip proxy ip: 136.10.1.138 # @IP GSI if different from the aastra.cfg generic config file#sip registrar ip: 136.10.1.138 # @IP GSI if different from the aastra.cfg generic config file#...sip line1 screen name: 3010 # Name displayed - line 1sip line1 user name: 3010 # Subscriber - line 1sip line2 screen name: 3010->5000 # Name displayed - line 2sip line2 user name: 5000 # Subscriber - line 2#...sip line1 proxy ip: 192.168.65.2 # @IP GSI _ line 1sip line2 proxy ip: 192.168.65.250 # @IP GSI _ line 2#...sip line1 proxy port: 5060 # port 5060 _ line 1sip line2 proxy port: 5060 # port 5060 _ line 2#...sip line1 registrar ip: 192.168.65.2 # @IP GSI _ line 1sip line2 registrar ip: 192.168.65.250 # @IP GSI _ line 2
