Operational, Basic, and Advanced Parameters41-001160-03, Rev 00, Release 2.4 A-65SIP Local Dial Plan SettingsParameter –sip dial planLocal Dial Plan(in Web UI)Aastra Web UI Basic Settings->PreferencesConfiguration Files aastra.cfg, .cfgDescription A dial plan describes the number and pattern of digits that a user dials toreach a particular telephone number. The SIP local dial plan is as follows:Symbol Description0, 1, 2, 3, 4, 5, 6, 7, 8, 9 Digit symbolX Match any digit symbol (wildcard)*, #, . Other keypad symbol; # can terminatea dial string| Expression inclusive OR+ 0 or more of the preceding digit symbolor [] expression[] Symbol inclusive OR- Used only with [], represent a range ofacceptable symbols; For example, [2-8]“,” (open/close quotes) In the configuration files, enter the sip dialplan value using quotes..;. Used when a secondary dial tone isrequired on the phone. (For example,“9;xxxxxx”, when a user has to dial “9” to getand outside line and needs a secondary dialtone presented.Note: You can configure prefix dialing by adding a prepend digit to thedial string. For example, if you add a prepend map of“[2-9]XXXXXXXXX,91”, the IP phone adds the digits “91” to any 10-digitnumber beginning with any digit from 2 to 9 that is dialed out. Otherexamples of prepend mappings are:• 1X+#,9 (Prepends 9 to any digit string beginning with “1” andterminating with “#”.)• 6XXX,579 (Prepends “579” to any 4-digit string starting with “6”.)• [4-6]XXXXXX,78 (Prepends “78” to any 7-digit string starting with “4”,“5”, or “6”.Format Alphanumeric charactersDefault Value X+#|XX+*Range Up to 512 alphanumeric characters.Note: If a User enters a dial plan longer than 512 characters, or a parsingerror occurs, the phone uses the default dial plan of “x+#|xx+*”. If this isthe case, the Administrator cannot change the dial plan from theconfiguration files. The dial plan must be changed from the Aastra WebUI.Example sip dial plan: "X+#|XXX+*"Draft 1
