Operational, Basic, and Advanced ParametersA-104 41-001343-02 REV05 – 07.2014Autodial SettingsGlobal SettingsPer-Line SettingsParameter –sip autodial numberConfiguration Filesaastra.cfg, .cfg, .cfgDescription Globally specifies the SIP phone number that the IP phone autodials when the handsetis lifted from the phone cradle. An empty (blank) value disables autodial on the phone.Format IntegerDefault Value BlankRange Any valid SIP numberExamples sip autodial number: 8500Parameter –sip autodial timeoutConfiguration Filesaastra.cfg, .cfg, .cfgDescription Globally specifies the time, in seconds, that the phone waits to dial a pre-configurednumber after the handset is lifted from the IP phone cradle.If this parameter is set to 0 (hotline), the phone immediately dials a pre-configurednumber when you lift the handset. If this parameter is set to a value greater than 0, thephone waits the specified number of seconds before dialing the pre-configurednumber (warmline) when you lift the handset.Default is 0 (hotline).Format IntegerDefault Value 0Range 0-120Examples sip autodial timeout: 30Parameter –sip lineN autodial number(N is a line number from 1 to 9)Configuration Filesaastra.cfg, .cfg, .cfgDescription On a per-line basis, this parameter specifies the SIP phone number that the IP phoneautodials when the handset is lifted from the phone cradle. Valid values can be:• -1 (Default): The phone uses the global autodial setting for this line.• Blank (Empty field): Disables autodial on this line.• Valid SIP Number: Dials the SIP number specified for this line.Format IntegerDefault Value -1Range Any valid SIP number.Examples sip line1 autodial number: 8500
