A&D GP-61KS Instruction Manual

Contents

A&D GP-61KS Instruction Manual Manual pdf 67 page image

6511-5 Memory for Comparator Settingsz The data memory function can store 20 sets of upper and lower limit values for the comparator mode.The reference value or tolerance value for the comparator mode can not be stored in memory.z The upper and lower limit values in memory can be recalled easily using the MODE key andused for weighing.z The upper and lower limit values in memory can be recalled and changed.NoteThe recalled upper and lower limit values can be changed, using the digital input mode or theweighing input mode. The digital input mode enters the upper and lower limit values usingthe keys. The weighing input mode uses a sample to store the upper and lower limit values.Storing the upper and lower limit valuesTo store new upper and lower limit values: Recall the stored upper and lower limit values to bechanged (“C01” to “C20”). Then, change the recalled upper and lower limit values using the digitalinput mode or the weighing input mode, and store the new value.1 Press the MODE key to select a unit to be used for storage.NoteWhile the data memory function is in use, unit selection using the MODE key is not available.2 Set the “Data memory (data)” parameter to “4”.If “Clr” appears blinking in the upper left of the display, delete the data in memory asdescribed in “11-1 Notes on Using Data Memory”.3 Press and hold the PRINT key until the balance enters the upper and lower limit valuesconfirmation mode. The upper limit value last selected is displayed as shown below.All the digits blinking4 Select the comparator number to be used, using the following keys.RE-ZERO key To increase the comparator number by one.MODE key To decrease the comparator number by one.Each time the RE-ZERO key or MODE key is pressed, the displayedvalue changes as follows: .... ↔ C03 HI ↔ C03 LO ↔ C04 HI ↔ C04 LO↔ ....5 To change the selected upper and lower limit values:To use the digital input mode, press the SAMPLE key to enter the digital input mode. Go to“Digital input mode” on the next page.To use the weighing input mode, press the SAMPLE key, then press and hold the MODE keyto enter the weighing input mode. Go to “Weighing input mode” on the next page.NoteUsing the “CN:mm” command, the upper and lower limit values can be recalled. (mmindicates a two-digit numerical value 01-20, which corresponds to C01-C20.) The upper andlower limit values recalled can be output using the “?HI” command or “?LO” command andcan be changed using the “HI:” command or “LO:” command.