A&D GP-61KS Instruction Manual

Contents

A&D GP-61KS Instruction Manual Manual pdf 44 page image

429-5 Description of the Item “Data output mode”The parameter setting of “Data output mode (prt)” applies to the performance when the “Datamemory (data)” parameter is set to “2” (to store the weighing data) and when the data is transmittedusing the RS-232C interface.Key modeWhen the PRINT key is pressed with the stabilization indictor turned on, the balance outputs orstores the weighing data and the display blinks one time.Required setting dout prt 0 Key modeAuto print modes A and BWhen the displayed value is stable and the conditions of “Auto print polarity”, “Auto print difference”and reference value are met, the balance outputs or stores the weighing data.When the PRINT key is pressed with the stabilization indictor turned on, the balance outputs orstores the data and the display blinks one time.Mode A: Required setting dout prt 1 Auto print mode A (reference = zero)dout ap-p Auto print polaritydout ap-b Auto print differenceExample “For weighing each time a sample is placed and removed,with “ar-d” set to “1” (to adjust zero after the data is output).”Mode B: Required setting dout prt 2 Auto print mode B (reference =last stable value)dout ap-p Auto print polaritydout ap-b Auto print differenceExample “For weighing while a sample is added.”Stream modeThe balance outputs the weighing data continuously regardless of the display condition. The displaydoes not blink in this mode. This mode is not available and the interval memory mode is used whenthe “Data memory (data)” parameter is set to “2” (to store the weighing data).Required setting dout prt 3 Stream modedout data 0 Data memory function is not used.ba5fnc 5pd Display refresh rate5if bp5 Baud rateExample “For monitoring data on a computer”CautionThe balance may not transmit the data completely at the specified refresh rate, depending onthe baud rate or data added to the weighing data such as time, date and ID number.