A&D GF-30K Instruction Manual

Contents

A&D GF-30K Instruction Manual Manual pdf 25 page image

237-2. Self Check Function With Response Adjustment For The GX-K SeriesThis function automatically updates the response adjustment by analyzing the influence ofthe environment on the weighing data and also self-checks the balance performance usingthe internal mass.Step 1 Press and hold the MODE key until RESPONSE isdisplayed, and then release the key.Step 2 The balance automatically starts to check the balanceperformance and sets the response characteristic.Caution Do not allow vibration or drafts to affect thebalance during adjustment.Step 3 After automatic adjustment, the balance displays the updatedresponse indicator and returns to the weighing mode.The response indicator remains displayed for a while.Example of displayMID. and OK : The example above indicates that the result of the self checkis good and MID. is selected as the response rate..NoteIf improper performance is found in the self check, the balance displays CH no .Contact the local A&D dealer for repair.If the automatic response adjustment fails, the balance displays CH ng . Check theambient conditions such as breeze and vibration, also check the weighing pan. Then,perform the adjustment again. To return to the weighing mode, press the CAL key.AdviseIf the automatic response adjustment is not helpful, try to refine it using the "7-3. Self CheckFunction For GF-K Series".7-3. Self Check Function For GF-K SeriesThis function manually updates the response adjustment by analyzing the influence of theenvironment on the weighing data.Step 1 Press and hold the MODE key until RESPONSE is displayed.And then, press the MODE key again quickly.Step 2 Press the MODE key to select a weighing speed.Either FAST , MID. or SLOW can be selected.Step 3 After a few seconds of inactivity the balance displays end .Then, it returns to the weighing mode and displays theupdated response indicator.The response indicator remains displayed for a while.NoteIf improper performance is found in the self check, the balance displays CH no .Contact the local A&D dealer for repair.ResultPress and holdReleaseResultPress and holdRelease