AGA GC Installation Instructions Manual

Also see for GC: Installation instructions Installation instructions User instructions Operating instructions Installation instructions

Contents

AGA GC Installation Instructions Manual Manual pdf 4 page image

GC, GE Open Flue ModelsMaximum Heat Input: 4.4kw (15,000 (Btu/h)GC, GE Direct Vent ModelsThe appliance and its individual shut-off valve must bedisconnected from the gas supply piping system duringany pressure testing of that system at test pressures inexcess of 1/2 psig (3.5kPa). The appliance must beisolated from the gas supply piping system by closing theindividual manual shut-off valve during any pressuretesting of the gas supply piping system at test pressuresequal to or less than 1/2 psig (3.5kPa).The model and serial numbers for this appliance are foundon the name plate. These numbers must be used whenrequesting advice from your Aga Distributor. The nameplate is located on the inside face of the outer burnerdoor. The maximum gas inlet pressure at the appliancemust not exceed 12 inches w.g. (2.98kPa) for Natural Gasand 14 inches w.g. (3.48kPa) for L.P. Gas. The minimumgas inlet pressure at the appliance must be 4 inches w.g.(1kPa) Natural Gas and 10 inched w.g. (2.248kPa) L.P. Gasto enable the correct manifold pressure to be obtained.4LOCATION OF NAME PLATE