Installation818 42 69- 00/2 11The Refrigerator needs VentilationAir is fed under the door through thevent slots in the base and isexhausted upwards along the backwall. To ensure proper air circulationnever cover or alter the ventopenings.Important! If the appliance isinstalled under a hanging cabinet, aclearance of at least 10 cm betweenthe top of the appliance and thecabinet above it must be maintained.Please check whether, after installingyour appliance and especially afterreversing the door, the door seal fitstightly. A badly fitting door seal maylead to heavy frosting and a higherpower consumption (see also"Something not working“).Appliance Alignment0 1. The appliance must be level, please compensate for unevenness in thefloor by turning the two adjustable feet at the front.Electrical ConnectionA properly installed socket outlet with earthing contact is required forelectrical connection. Electrical fuse protection must be of at least 10ampere.If the outlet socket is no longer accessible after installation of theappliance, appropriate measures must be taken during electrical instal-lation to assure that the appliance can be disconnected from the mains(e.g. fuse, circuit breaker, non-operate current safety-switch or the like,with a contact opening of at least 3 mm).0 1. Before initial start-up, refer to the appliance rating plate to ascertain ifsupply voltage and current values correspond with those of the mainsat the installation location.e.g.: AC 220 ... 240 V 50 Hz or220 ... 240 V~50 Hz(i.e. 220 to 240 volts alternating current, 50 Hertz)The rating plate is inside the appliance at the left.