AEG BP5304001M User Manual

AEG BP5304001M User Manual Manual pdf 30 page image

10.4 Cleaning reminderTo remind you that the Pyrolysis isnecessary, PYR flashes in the display for10 seconds after each activation anddeactivation of the appliance.The cleaning remindergoes out:• after the end of thePyrolysis function.• if you press and atthe same time while PYRflashes in the display.10.5 Removing and installingthe doorYou can remove the door and theinternal glass panels to clean it. Thenumber of glass panels is different fordifferent models.WARNING!Be careful when you removethe door from the appliance.The door is heavy.1. Open the door fully.2. Fully press the clamping levers (A) onthe two door hinges.A A3. Close the oven door to the firstopening position (approximately 70°angle).4. Hold the door with one hand on eachside and pull it away from theappliance at an upwards angle.5. Put the door with the outer sidedown on a soft cloth on a stablesurface. This is to prevent scratches.6. Hold the door trim (B) on the topedge of the door at the two sidesand push inwards to release the clipseal.12B7. Pull the door trim to the front toremove it.8. Hold the door glass panels on theirtop edge one by one and pull themup out of the guide.9. Clean the glass panel with water andsoap. Dry the glass panel carefully.When the cleaning is completed, do theabove steps in the opposite sequence.Install the smaller panel first, then thelarger and the door.WARNING!Make sure that the glassesare inserted in the correctposition otherwise thesurface of the door mayoverheat.Make sure that you put the glass panels(C, B and A) back in the correctsequence. First, insert panel C, which hasa square printed on the left side and atriangle on the right side. You will alsofind those symbols embossed on thedoor frame. The triangle symbol on theglass must match the triangle on thedoor frame, and the square symbol mustmatch the square. After that insert theother two glass panels.www.aeg.com30