AEG BP5304001M User Manual

AEG BP5304001M User Manual Manual pdf 29 page image

• Clean all accessories after each useand let them dry. Use a soft cloth withwarm water and a cleaning agent.• If you have nonstick accessories, donot clean them using aggressiveagents, sharp-edged objects or adishwasher. It can cause damage tothe nonstick coating.10.2 Removing the shelfsupportsTo clean the oven, remove the shelfsupports.1. Pull the front of the shelf supportaway from the side wall.2. Pull the rear end of the shelf supportaway from the side wall and removeit.21Install the shelf supports in the oppositesequence.10.3 PyrolysisCAUTION!Remove all accessories andremovable shelf supports.Do not start the Pyrolysis ifyou did not fully close theoven door. In some models,the display shows "C3"when this error occurs.WARNING!The appliance becomes veryhot. There is a risk of burns.CAUTION!If there are other appliancesinstalled in the samecabinet, do not use themwhen the Pyrolysis functionoperates. It can causedamage to the appliance.1. Remove the worst dirt manually.2. Clean the inner side of the door withhot water, so that the residues do notburn from the hot air.3. Set the Pyrolysis function. Refer to"Oven functions".4. When flashes, press or toset the necessary procedure:Option DescriptionP1 If the oven isnot very dirty.Time of theprocedure: 2h 30 min.P2 If you cannoteasily removethe dirt. Timeof the proce-dure: 3 h.You can use the End function to delaythe start of the cleaning procedure.During the Pyrolysis the oven lamp is off.5. To change the default length of theprocedure (P1 or P2), press to set, and then press or to setthe length of the cleaning procedure.6. When the oven is at its settemperature, the door locks. Thedisplay shows the symbol and thebars of the heat indicator until thedoor unlocks.7. When Pyrolysis is completed, thedisplay shows the time of day. Theoven door stays locked.8. When the appliance is cool again, anacoustic signal sounds and the doorunlocks.ENGLISH 29