CARE AND CLEANINGWARNING!Refer to "Safety information" chapter.Notes on cleaning:• Clean the front of the appliance with a soft cloth with warm water and cleaning agent.• To clean metal surfaces use a usual cleaning agent• Clean the oven interior after each use. Thus you can remove dirt more easily and it doesnot burn on.• Clean stubborn dirt with a special oven cleaner.• Clean all oven accessories (with a soft cloth with warm water and cleaning agent) aftereach use and let them dry.• If you have nonstick accessories, do not clean them using an aggressive agents, sharpedged objects or dishwasher. It can cause a damage to the nonstick coating.Pyrolytic cleaningRemove all parts from the oven.The pyrolytic cleaning procedure cannot start:• If you do not remove the shelf rails or telescopic shelf runners (if supplied), the clockdisplay shows 'C1'• if you do not close the oven door correctly (the clock display shows „C3“) .1. Remove the worst of the residual dirt manually.2. Set the Pyrolytic cleaning function (refer to section "Oven functions").3. When flashes, press or to set the necessary procedure:– P1 2:15 for a low degree of dirt,– P2 2:45 for a usual degree of dirt,After 2 seconds procedure starts.To change length of selected procedure ( P1 or P2 ), press to set , then press orto set length for the pyrolytic procedure.You can use the End function to delay start of the cleaning process.When the oven reaches pre-set temperature, the door locks. The symbol and the bars ofthe heat indicator come up, until the door unlocks again.During pyrolytic cleaning the lamp is off.Cleaning reminderTo remind you that the pyrolytic cleaning is necessary the cleaning reminder symbol flashesin the display PYR after every activating and deactivating the appliance for the next 10seconds.The cleaning reminder goes off the display:• after end of the pyrolytic cleaning function;• if you use or , when is flashing;Care and cleaning 25