Menu
ADTRAN T200 H2TU-R Installation And Maintenance Manual
Also see for T400: Installation and MaintenanceInstallation & maintenanceInstallation and MaintenanceInstallation and MaintenanceInstallation and Maintenance
                     | |
Contents
| 
6 Section 61150090L1-5A, Issue 1 61150090L1-5A9. Hoist the cabinet to an upright position andcenter it over the pad.CAUTIONThe minimum internal bend radius for cablestubs is nine inches.10. At this time, on the cable stub model, the cablestubs should be fed through their designatedconduit or other route per craft plan.11. Lower the cabinet with attached brackets ontothe pad ensuring the four bottom bracket5/8 inch bolt holes align with the pad fastenerarrangement. Secure with customer suppliedfasteners. Continue feeding the cable stubs as thecabinet is lowered.12. On the ground lug on the cabinet bottom next tothe spare cable penetration attach anappropriately sized (6 AWG) ground cable to themost direct path to ground. Ground cable andconnectors are customer supplied.CAUTIONWithout positive ground surge protection islost.13. After the cabinet is secured to the pad the frontand back security access covers can be installedon the pad mounting brackets using the includedfasteners. Tighten to 10-15 in-lbs. Install withthe access cover lip facing in and against thecabinet’s bottom panel. See Figure 4.13. If lifting details are to be removed, replace thefasteners removed in step 4 ensuring the sealingwashers are installed next to the cabinet sidepanels.Pole Mount InstallationPole mounting has two configurations:• Mounted to a single pole on either the left orright side panel.• H-frame where the cabinet is supported by aframe arrangement at either the left or right sidepanel.The pole-mount or H-frame support structure mustbear the weight of a fully equipped cabinet (200 Lbs).The weight and the distance the cabinet will beinstalled above the ground determines the type of poleconfiguration to be selected. Refer to Figure 7 forpole mount access clearances.1. At the installation site remove all packagingmaterial enclosing the cabinet.2. Remove and set aside the Mounting HardwareKit. Verify kit contents per Table 3.3. The cabinet is bolted to two boards runningacross the wood box frame. Remove the screwssecuring the two boards to the wood box frame.Figure 7. Pole Mount DimensionsPad mounted stud*(4 places)*Customer suppliedMountingBracketnut*splitwasher*flatwasher* bolt torque:100-110 in-lbsPad arrangement is representativesealing washer5/8" diaFigure 6. Pad Mounting Bracket Installation33"top to bottombrackets included63"overall withdoors open |
Related manuals for ADTRAN T400
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved