ADEMCO VISTA-20PS User Manual

Also see for VISTA-15P Series: Quick installation guide User guide Installation and setup guide Installation and setup guide Programming guide

Contents

ADEMCO VISTA-20PS User Manual Manual pdf 33 page image

– 33 –Security Codes & Authority Levels (cont’d)How to Assign User Codes and AttributesThe following lists the various command strings for adding user codes and attributes.Refer to the User Setup chart at the back of this manual for factory defaults ofuser attributes and to keep a record of user programming.NOTE: Partition Master codes (VISTA-20P/PS Series only) apply only to those usernumbers previously assigned (by the system master/installer) to the partition master’spartition.Add User Code: System/Partition Master code + [8] + user no. + new user’s code(Users 03/33 are preset User 01 = installer User 03 = partition 1 masterto partition programmers, User 02 = master User 33 = partition 2 masterbut can be changed.) The Keypad beeps once to confirm that new user was added.Delete User Code: System/Partition Master code + [8] + [user no.] + [#] [0]The user code and all attributes* programmed for this user number,including any associated RF keys, are erased from the system.(*except assigned partition)Authority Level: System/Partition Master code + [8] + [user no.] + [#] [1]+ auth. levelFactory Defaults: Authority Levels (see definitions on previous page):users 04-32/34-49 = 0 0 = standard user 3 = duressusers 03/33 = 4 1 = arm only 4 = partition master (VISTA-20P/PS Series2 = guest only)Access Group: System/Partition Master Code + [8] + [user no.] + [#] [2]+ group (1-8)Factory Defaults:: none You can assign users to a group, then set an access schedule thatdefines the times this group of users can operate the system. Thesystem ignores these users outside the scheduled times.User’s Partition: System Master Code + [8] + [user no.] + [#] [3] + [0] + partition(s) + [#](VISTA-20P only) This command assigns the partitions the user can access. If moreFactory Defaults: than one, enter partition numbers sequentially, then press [#] to end.Part. 1 = users 03-32 E.g., master code + [8] + [user no.] + [#] [3] + [0] + [1] [2] + [#] givesPart. 2 = users 33-49 the user access to partitions 1 and 2 and the common partition.Partition Entries: 1 = partition 1 and common2 = partition 2 and common3 = common partition onlyRF User Number: Master/Part. Prog. Code + [8] + [user no.] + [#] [4]+ zone no.Factory Defaults:: none Use this command to assign a wireless button device (keyfob) to thisuser (keyfob must be enrolled in system first; see installer).Zone number: enter the zone number assigned to a button on thekeyfob that will be used for arming/disarming by this user.Pager On/Off: Master/Part. Prog. Code + [8] + [user no.] + [#] [5] + 0 or 1Factory Defaults: You can program a user so that a message is sent to a pagerusers 01-04 = 0 (off) whenever this code is used to arm or disarm the system.users 05-49 = 1 (on) Paging On/Off: 1 = allow paging; 0 = no paging for this user