ADEMCO VISTA-20PS User Manual

Also see for VISTA-15P Series: Quick installation guide User guide Installation and setup guide Installation and setup guide Programming guide

Contents

ADEMCO VISTA-20PS User Manual Manual pdf 22 page image

– 22 –Bypassing Protection ZonesUsing the BYPASS KeyUse t his key when you want to arm your system with one or more zonesintentionally unprotected. The system must be disarmed first.Vent Zones: Your system may have certain windows set as “vent” zones, which areautomatically bypassed if left open when arming the system (you do not need tomanually bypass them). However, if a vent zone window is closed after arming, itbecomes protected and will cause an alarm if opened again while the system isarmed.When bypassing zones:• The system must be disarmed before you can bypass zones.• Bypassed zones are unprotected and will not cause an alarm if violated.• The system will not allow fire zones to be bypassed.• Zones are automatically unbypassed when the system is disarmed.1. + 6BYPASS + zone numbers (see below)(Security Code)Enter the 2-digit zone number(s) for the zone(s) to bebypassed (e.g., 06, 10, 13, etc.). Single digit zonenumbers must be preceded by a zero (e.g. 05, 06).Alpha Display:DISARMED - PRESS* TO SHOW FAULTSFixed-Word Display:NOT READY2. When finished, the keypad will momentarily display a"Bypass" message for each bypassed zone number.Wait for all bypassed zones to be displayed.Arm the system as usual. When armed, the armingmessage is displayed with “ZONE BYPASSED.”To display bypassed zones prior to arming, enteryour security code and press the [6] BYPASS key.Alpha Display:DISARMED BYPASSREADY TO ARMFixed-Word Display: BYPASSAlpha Display:ARMED: STAYZONE BYPASSEDTypical armed display afterbypassing zones.