– 45 –Using #70 Relay Menu ModeGeneral InformationYour system may be set up so that certain lights or other devices canbe turned on or off by using the #70 command from either a keypad ora telephone keypad (if 4285 or 4286 VIP module is used). Ask yourinstaller if this has been done in your system.To activate relays from a keypad, enter 4-digit security code + [#]+70. Follow the keypad prompts described below.To activate relays using a telephone and 4285 or 4286 VIPmodule, first dial the 2-digit phone access code. When the systemacknowledges the access, enter 4-digit security code + [#] + 70. Thefollowing prompts/voice responses will begin.ENTER DEVICE NO.00=QUIT 01 Voice: "ENTER DEVICE CODE NOW"Enter the 2-digit number of the device to beactivated.Note that if an invalid number is entered, thesystem will simply ask you to reenter thenumber.NN DEVICE IS OFFHIT 0=OFF , 1=ON Voice: "voice descriptor DEVICE nn ON/OFF.FOR voice descriptor ON ENTER 1, FOR voicedescriptor OFF ENTER 0"Press 0 or 1 to turn the device off or onrespectively."nn" represents the 2-digit device number andvoice descriptor is the relay voice descriptorprogrammed by the installer.
