ADEMCO VISTA-100 Isntallation Instructions And Programming Manual

Also see for VISTA-100: User guide Quick start User guide Installation instructions

Contents

ADEMCO VISTA-100 Isntallation Instructions And Programming Manual Manual pdf 48 page image

8-1S E C T I O N 8Wireless Zone Expansion• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •In This Section© Common Characteristics of Wireless Zones© Wireless Systems Available© RF System Operation and Supervision© RF System Installation Advisories© Installation and Setup of the 4281/5881 RF Receiver© Programming the RF Receiver© House ID Sniffer Mode© 5700 Series Transmitter Setup© 5800 Series Transmitter Setup© Programming and Checkout of Wireless Zones• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •Common Characteristics of Wireless Zones• Supervised by control panel for check-in signals (except certain nonsupervisedtransmitters)• Individually assignable to one of 8 partitions• Individually assignable to bell outputs and/or aux. relayUL Wireless devices may not be used in UL Commercial Burglary installations. UL Listing of the5808 Smoke Detector for Commercial Fire installations is pending.Wireless Systems AvailableThe VISTA-100 supports wireless zones which may be used exclusively or in addition tohardwire and/or polling loop zones. The system supports two different wireless systemswhich have many similarities, but notable differences in the programming of thetransmitters for each system.The following receivers may be used with this system. Each supports the number of zonesshown below:5700 SeriesReceiver Zones4281L up to 44281M up to 84281H up to 63