Section 27 - User Access Codes27-3Note that Open/Close reporting of Quick Arm is enabled if User 002 is enabled forOpen/Close reporting, and that Quick Arm reports as User 000. In order for Quick Armreports to be sent for all partitions, User 002 must have authority and Open/Close must beenabled for all partitions. If you do not want a code with access to all partitions, User 002should be assigned authority level 5 in all partitions, and the code should be kept secret. Aperson with authority level 5 cannot disarm the system unless he armed it.ADEMCO Contact ID format is capable of reporting Users 001-128 uniquely. If any other reportformat is used, only user numbers 001 - 015 can uniquely report to the central station. Users 016-128 will report as User 015.Multiple Partition Access ExamplesEach user is programmed for a primary (home) partition. You can also give a user thecapability to operate one or more additional partitions. Within each partition, you canprogram each user to have a different level of authority. For example, User 3, the VicePresident of Engineering, could be assigned to work within the Engineering Department(Partition 1) of ABC Manufacturing. Since he needs the full capabilities in his area, he isassigned as a master with Level 1 authority. This means he can arm, disarm, bypass, addusers or modify users in Partition 1.He must also be able to gain access to the manufacturing area (Partition 2) on an emergencybasis. You can set this up easily with the partitioned system by requesting that he also beassigned to Partition 2, with a level of authority set lower, such as Level 4 (Operator LevelB), which allows him to arm and disarm, but nothing else. The control will automaticallyassign him the same user number within Partition 2, and does not require reprogrammingof his already existing 4-digit security code.EXAMPLE OF MULTIPLE PARTITION ACCESSPart 1 Part 2 Part 3 Part 4 Part 5 Part 6 Part 7 Part 8User 3 User 3Level 1 Level 4Master Oper BIn the above example, User 3 has Master authority in Partition 1 andOperator B authority in Partition 2. His user number is the same forboth partitions. Note that if a user number is already in use in apartition, the system will automatically assign an unused user number toa new user. Also notice that no access is allowed for this user intoPartitions 3 through 8. Attempts to access these partitions are deniedautomatically.To ADD a Master, Manager, or Operator CodeDuring user code entry, normal key depressions at other keypads in a partition will be ignored;however, panic key depression will cause an alarm and terminate user entry.To add a Master, Manager, or Operator Code, take the following steps:1. Enter [Installer Code†] + 8 + [new user # (002-128)] + [new user's code].†Rather than an Installer Code, you could enter a Master or Manager Code, as long as it hasa higher level of authority than the code you want to add.2. The keypad will prompt you for the authority level for the new user.
