ADC ADH-120 Installation Manual

ADC ADH-120 Installation Manual Manual pdf 37 page image

33K. OPERATING INSTRUCTIONSNOTE: Before attempting to start the dryer make sure that the main door and lint door is closed.1. To Start The Dryer.a. Microprocessor controller (computer) dryers1) Display will read “FILL” (meaning no cycle in progress).2) Press the letter on the keyboard (touch pad) corresponding to the cycle desired (i.e., “E”)...a) The dryer will then start (rotate).3) Light emitting diode (L.E.D.) display will now show the cycle in progress and cycle status (i.e.,“dr30”) meaning that the dryer is in the drying cycle (dry mode for 30 minutes) and count down inminutes.NOTE: Pressing keyboard (touch pad) key “A,” “B,” “C,” “D,” and “F” will also start the dryer. Thesix (6) preprogrammed drying cycles (“A” through “F”) have been stored in the microprocessorcontroller’s (computer’s) memory. Refer to the Computer Programming Manual supplied withdryer for more specific operating information.NOTE: The dryer can be stopped at any time by pressing the “CLEAR/STOP” key. To restart thedryer, press the “ENTER/START” key or preprogrammed cycle key (i.e., “E”).NOTE: Selection (setting) changes can be made at any time during the drying cycle by pressing the“CLEAR/STOP” key twice. The L.E.D. display will return to “FILL” at which time a newcycle selection can be made.L. SHUT DOWN INSTRUCTIONSIf the dryer is to be shut down (taken out of service) for a period of time, the following must be performed:1. Discontinue power to the dryer either at the external disconnect switch or the circuit breaker.2. Discontinue the steam supply.a. SHUT OFF steam valves in the supply lines and the return lines.