ADC ADH-120 Installation Manual

ADC ADH-120 Installation Manual Manual pdf 14 page image

10SECTION IIIINSTALLATION PROCEDURESInstallation should be performed by competent technicians in accordance with local and state codes. In theabsence of these codes, the installation must conform to applicable American National Standards: ANSI Z223.1-LATEST EDITION (National Fuel Gas Code) or ANSI/NFPA NO. 70-LATEST EDITION (National ElectricalCode) or in Canada, the installation must conform to applicable Canadian Standards: CAN/CGA-B149.1-M91(Natural Gas) or CAN/CGA-B149.2-M91 (Liquid Propane [L.P.] Gas) or LATEST EDITION (for GeneralInstallation and Gas Plumbing) or Canadian Electrical Codes Parts 1 and 2 CSA C22.1-1990 or LATEST EDITION(for Electrical Connections).A. LOCATION REQUIREMENTSBefore installing the dryer, be sure the location conforms to local codes and ordinances. In the absence of suchcodes or ordinances the location must conform to the National Fuel Gas Code ANSI.Z223.1 LATEST EDITION,or in Canada, the installation must conform to applicable Canadian Standards: CAN/CGA-B149.1-M91 (NaturalGas) or CAN/CGA-B149.2-M91 (L.P. Gas) or LATEST EDITION (for General Installation and Gas Plumbing).1. The dryer must be installed on a sound level floor capable of supporting its weight. Carpeting must beremoved from the floor area that the dryer is to rest on.IMPORTANT: “The dryer must be installed on noncombustible floors only.”2. The dryer must not be installed or stored in an area where it will be exposed to water and/or weather.3. Provisions for adequate air supply must be provided as noted in this manual (refer to Fresh Air SupplyRequirements in Section D).4. Clearance provisions must be made from combustible construction as noted in this manual (refer to DryerEnclosure Requirements in Section C).5. Provisions must be made for adequate clearances for servicing and for operation as noted in this manual(refer to Dryer Enclosure Requirements in Section C).6. Dryer must be exhausted to the outdoors as noted in this manual (refer to Exhaust Requirements inSection E).7. Dryer must be located in an area where correct exhaust venting can be achieved as noted in this manual(refer to Exhaust Requirements in Section E).8. Dryer must be located in an area where correct exhaust venting can be achieved as noted in this manual(refer to Exhaust Requirements in Section E).IMPORTANT: Dryer should be located where a minimum amount of exhaust duct will be necessary.