ADC AD-35i Installation & Operator's Manual

Contents

ADC AD-35i Installation & Operator's Manual Manual pdf 22 page image

22 American Dryer Corp. WFR113539 - 13Input connection wiring must be sized properly to handle thedryer’s current draw. This information is printed on the dryer’srating plate.IMPORTANT: A strain relief must be used where the inputwiring enters.Gas Information _______________________It is your responsibility to have all plumbing connections,materials, and workmanship conform to local and stateregulations or codes of the country of destination. In theabsence of such codes, all plumbing connections, materials,and workmanship must conform to the applicable localrequirements. In the USA this is the National Fuel Gas CodeANSI Z223.1-LATEST EDITION, or in Canada, the CanadianInstallation Codes CAN/CGA-B149.1-M91 (Natural Gas) orCAN/CGAB149.2-M91 (Propane Gas) or LATEST EDITION.In Australia, the fuel gas code is AS/NZS5601, local authority,gas, electricity, and any other relevant statutory regulations.It is important that gas pressure regulators meet applicablepressure requirements, and that gas meters be rated for thetotal amount of all the appliance Btu being supplied.IMPORTANT: Failure to comply with these codes orordinances, and/or the requirements stipulated in thismanual, can result in personal injury and improperoperation of the dryer.For ease of service, the individual gas supply line of eachdryer must have its own manual shutoff valve.The dryer and its individual shutoff valve must bedisconnected from the gas supply piping system during anypressure testing of that system at test pressures in excessof 1/2 psig (3.5 kPa) for non-CE dryers or 50 mb for CEdryers.IMPORTANT: Failure to isolate or disconnect the dryer fromsupply as noted can cause irreparable damage to the gasvalve, voiding the warranty.NOTE: The dryer must be isolated from the gas supplypiping system by closing its individual manual shutoff valveduring any pressure test of the gas supply system at testpressures equal to or less than 1/2 psig (3.5 kPa) for non-CE dryers or 50 mb for CE dryers.! WARNINGFire or explosion could result due to failure ofisolating or disconnecting the gas supply as noted.NOTE: Undersized gas piping will result in ignitionproblems, slow drying, increased use of energy, and cancreate a safety hazard.The dryer must be connected to the type of heat/gas indicatedon the rating plate and pressure must be confirmed. If thisinformation does not agree with the type of gas available, donot operate the dryer. Contact the reseller who sold the dryeror contact the manufacturer.3-Phase (3ø) Electric HeatWiring ConnectionsFor 208V-480V ApplicationsBlackL1WhiteL2RedL3GreenGroundScrewCAUTION: The dryer must be grounded. A groundblock has been provided for this purpose.