30 | XSE RI ES G5 | 2106026MNAAFigure 3-1: Mounting pipeLegend: Mounting pipe1 Meter run 3 Saddle2 2-inch x 40-inch Mounting pipe 4 U Mounting boltScrew the mounting pipe into the saddle until it is tight.Level the mounting pipe:a. Level and center the pipe and saddle on the top of the meter run. Tighten the saddle-mounting U-bolt.b. Level the pipe so that the pipe is perpendicular to the meter run using the saddleleveling bolts (if available) on the mounting saddle.Tighten the saddle-mounting U-bolt as tight as possible to avoid vibration-related issues.Install the XFCG5 or XRCG5 mounting brackets to the back of the enclosure using the pipemount instructions supplied in the mounting kit.Attach the enclosure to the mounting pipe:a. Hold the enclosure in place against the mounting pipe and insert a U-bolt around thepipe and through the corresponding holes on the upper mounting bracket.c. Add the flat washer and split washer onto the U-bolt, then screw the nut onto the U-bolt.d. Repeat steps 6a and 6b for the second mounting bracket.Raise the XFCG5 or XRCG5 into position on the mounting pipe.IMPORTANT NOTE: Position the XFCG5 or XRCG5 high enough to allow some downwardslope from the externally mounted manifold to the tap valves.Secure the XFCG5 or XRCG5 in place by tightening the U-bolt nuts. This will help to avoidvibration-related issues.For the XFCG5: To install the manifold and connect the input lines to the meter run, see section 3.6Direct-mount installation.IMPORTANT NOTE: Select a mounting location that allows for easy access, is close to the tapvalves, and complies with all local and national codes.
