ABB TZIDC-200 Operating Instructions Manual

Also see for TZIDC-200: Manual Manual Commissioning instructions Operating instruction Operating instruction

ABB TZIDC-200 Operating Instructions Manual Manual pdf 32 page image

Commissioning32 TZIDC-200, TZIDC-210, TZIDC-220 42/18-85-EN7.2 TZIDC-210 / TZIDC-220bieten1. Feed in pneumatic supply power2. Connect the bus to the bus terminals with any polarity (or supply power 9 ... 32 V DC)is displayed3. Check mount:• Press and hold down and ; once the countdown has gone from 3 to 0,release and ; the unit switches to the operating level, mode 1.x• Press and hold down and .• Additionally, press or until operating mode 1.3 (manual adjustment within the sensorrange) is displayed. Release• Press or to move the actuator into the mechanical end position; check the endpositions; rotation angle is displayed in degrees (for high-speed mode, press andsimultaneously)Recommended range:- between -28 ... 28° for linear actuators- between -57 ... 57° for rotary actuatorsMinimum angle: 25°4. Go back to the bus level:• Press and hold down and ; once the countdown has gone from 3 to 0,release andis displayed.5. Run Autoadjust• Check that the unit is on the bus level ("REMOTE")For linear actuators 1) :• Press and hold down until is displayed. Release the control button• Press again and hold down until the countdown ends• Release ; this starts AutoadjustFor rotary actuators 1) :• Press and hold down until is displayed. Release the control button• Press again and hold down until the countdown ends• Release ; this starts AutoadjustmA% C°mA% C°