3Com 3C13751 Getting Started Manual

Also see for 3C13701: Installation guide Quick reference guide Installation guide Installation guide Module guide

3Com 3C13751 Getting Started Manual Manual pdf 46 page image

46 Chapter 3: Starting and Configuring the Router 5000Checking/operating after power-onAfter the router is powered on, please perform the following inspection.1 Whether the LEDs on the front panel are normal■ In the process of the Power On Self Test (POST), the LEDs light in thefollowing sequence: SLOT1 to 3 are ON first. Then, if SLOT 2 and 3 areON, it means that the memory test is successful. If SLOT 1 and 2 areON, it indicates the failure of the memory test.■ For the status of the LEDs during normal operation after power-on,please refer to Chapter 2 System Specifications.2 Whether the console terminal display is normalThe startup interface on the console terminal can be seen after the routeris powered on (see “Startup Process” below).After the startup (in other words, self-test), the user is prompted to press. When “<3Com>” is displayed, the user can proceed toconfigure the router.Startup Process The Router 5000 use the same version of Boot ROM program.After the startup of the router, Boot ROM program will be run first andthe following system information will be displayed on the terminalscreen:The interfaces displayed on the terminal may vary slightly with differentversions of Boot ROM.Router start booting,(V2.00)Starting at 0x1500000...********************************************* ** 3Com Router 5000 Boot ROM, V9.19 ** *********************************************Compiled at 12:17:34 , Jul 19 2005.Testing memory...OK!256M bytes SDRAM32768k bytes flash memoryHardware Version is MTR 1.0CPLD Version is CPLD 1.0Press Ctrl-B to enter Boot Menu