Radionics D6412 manuals
D6412
Brand: Radionics | Category: Controller
Table of contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Introduction
- Other Literature Referenced
- FCC Notice
- Overview
- Minimum Operating Voltage
- SIA Control Panel Standard
- Command Centers
- Control/Communicator Assembly
- Installation
- Installing the Assembly
- Finishing the Installation
- Make the Telephone Connections
- Power Supply
- Battery Supervision
- External Power Supply
- Output Programming
- Telephone Connections
- System Status LED (Red)
- Communication Failure
- Figure 8: Ground Start
- On-Board Sensor Loops
- Doubled Point Configuration
- Sensor Loop Response Time
- Off-Board Sensor Loops
- Table 5: Off-Board Sensor Loops - Location /Address Assignment
- D9528 Point Expander Module
- Figure 13: Installing the D9528 in the Panel's Enclosure
- D9528 to D6412 SDI Bus Connections
- D9528 Auxiliary Output Connections
- D9528 Tamper Input Connections
- D9528 Address Programming
- D9528 Status LED
- On-Board Outputs
- Off-Board Outputs
- D9529 to D6412 SDI Bus Wiring Connections
- Address Programming
- Arming Devices
- Command Center Installation
- D268/D269, D279 Independent Zone Control
- Keyswitch
- SDI Devices
- D9533 RS-232 Serial Interface Module
- D9533 Installation
- Configuration Jumpers
- Supervision
- Entering the Installer Mode
- Press [4] for Test Report
- Testing RF Devices
- Viewing/Removing RF ID Codes
- Exiting the Installer's Menu
- Press [0] Call for Service Details
- Installation Label
- Quick Reference Terminal Description
- Troubleshooting
- Appendix A: Approved Applications Compliance Guide
- Appendix A: System Chart
- Appendix A: System Wiring Diagrams, Issue A
- Appendix A: Current Rating Chart for Standby Battery Calculations
- Appendix A: Standby Battery Requirements
- Appendix B: SDI Address Chart
- Glossary
- Index