Lenovo 1027, 1029, 1039, 1040 manuals
1027, 1029, 1039, 1040
Table of contents
- Table Of Contents
- Table Of Contents
- Chapter 1. About this manual
- Important information about replacing RoHS compliant FRUs
- Chapter 2. General information
- Software programs
- Chapter 3. Diagnostics
- General problems
- Keyboard, mouse, or pointing-device problems
- Microprocessor problems
- Monitor problems
- Optional-device problems
- Power problems
- Serial port problems
- Software problems
- Solving Ethernet controller problems
- Event logs
- board
- Chapter 4. Locating parts, controls LEDs, and connectors
- Rear view
- Hot-swap hard disk drive status LEDs
- LEDs for the Ethernet connectors
- Locating parts on the system board
- Locating diagnostic LEDs on the system board
- drive backplanes
- Chapter 5. Replacing FRUs
- System reliability guidelines
- Working inside the server with the power on
- Guidelines for servicing electrical equipment
- Removing the server cover
- Removing and reinstalling the front bezel
- Locking or unlocking the hard disk drive side door
- Installing, removing, or replacing optional hardware devices
- installing a memory module
- removing a memory module
- Removing or installing internal drives
- removing the optical drive
- installing the optical drive
- removing a non-hot-swap hard disk drive
- installing a non-hot-swap hard disk drive
- Installing or removing a PCI card
- removing a pci card
- Installing or removing the Ethernet card
- removing the ethernet card
- Installing or removing the ThinkServer RAID 100 Upgrade Key for Advanced RAID
- Installing or removing the ThinkServer RAID 500 Upgrade Key for Advanced RAID
- Installing or removing the ThinkServer Remote Management Module 3
- installing the rmm
- Installing, removing, or replacing hardware devices
- connecting the mini sas cable
- assembly
- Removing or installing a front fan
- Removing or installing the rear fan
- removing the rear fan
- Removing or installing the microprocessor
- removing the microprocessor
- installing the microprocessor
- Replacing the system board battery
- Removing or installing the system board
- installing the system board
- Replacing the power supply assembly
- Completing the parts replacement
- Connecting the cables
- Turning off the server
- and 1040
- Power cords
- Chapter 7. Configuring the server
- Starting the Setup Utility program
- Using passwords
- RAID controllers
- Using the ThinkServer EasyStartup program
- Before you use the EasyStartup DVD
- Configuring RAID
- Starting the Intel Embedded Server RAID Technology II program
- Initializing the RAID volume
- Rebuilding the RAID volume
- Configuring the Gigabit Ethernet controller
- Updating the firmware
- Appendix A. RAID battery card assembly
- technical assistance
- Using other services
- Purchasing additional services
- Appendix C. Notices
- Trademarks
- Particulate contamination
- Compliance with Republic of Turkey Directive on the Restriction of Hazardous Substances
- German Ordinance for Work gloss statement
- Index