• If the non-hot-swap hard disk drive is secured in the bracket by screws, remove the four screws andthen remove the hard disk drive from the bracket.Figure37. Removing the screws that secure the hard disk drive• If the non-hot-swap hard disk drive is secured in the bracket by retainers, remove the retainers onboth sides and then remove the hard disk drive from the bracket.Figure38. Removing the retainers that secure the hard disk drive5. If you are instructed to return the removed non-hot-swap hard disk drive to the manufacturer, follow allpackaging instructions and use any packaging materials that are supplied to you for shipping.6. To complete the removal procedure, go to “Completing the parts replacement” on page 122.Installing a non-hot-swap hard disk driveAttention:Do not open your server or attempt any repair before reading and understanding the Safety Information and theWarranty and Support Information on the ThinkServer Documentation DVD that came with your product, and“Guidelines” on page 39. To obtain a copy of the publications, go to:http://www.lenovo.com/supportThis section provides instructions on how to install a non-hot-swap hard disk drive. This section appliesonly to server models that support non-hot-swap hard disk drives.Attention: To maintain proper system cooling, do not operate the server for more than 10 minutes withouteither a drive or a filler panel installed in each drive bay.To install a non-hot-swap hard disk drive, do the following:68 ThinkServer TD230 Hardware Maintenance Manual
