Menu
red lion Sixnet Series Hardware Manual
Also see for RAM 9000: Hardware guide
                                        | |
Contents
| 
RAM 9000 Series Hardware Guide 2-41Hardware Installation Revised 2015-07-16SD CardSD CardThe RAM 9000 has an SD memory card socket. This socket is found under a small door in the front face of the unit.Remove the one screw to access the SD card socket. To install an SD card, insert in the orientation show on thelabel until you hear a click. The SD card when properly inserted should sit just behind the door as shown below. Toremove the SD card push on the card until you hear a click, then remove pressure and the card will release.Note: A future firmware update is required to utilize the SD Card feature. Contact Red Lion for availability of thisfeature.I/O WiringThe RAM-96xx, RAM 97xx, and RAM-99xx models offer 2 discrete inputs, 2 discrete outputs, 1 relay output and 3analog inputs. The discrete inputs and outputs operate on the same voltage as the unit which is 8-30 VDC. Therelay output can switch an external power source up to 125 VAC. The analog inputs can accept current(0/4-20 mA)or voltage (0-10 VDC) inputs. The range is selectable in the software configuration.The pluggable screw block terminal is provided for the I/O wiring connections. Refer to the diagrams below onhow to make your I/O connections.Notes:• For relay wiring, use a minimum of 300V, 90°C rated wiring. Note: For ATEX / IECEx purposes, the relays are notapplicable.• Terminals are sized to hold 28 to 12 gauge wire, 12 AWG wire area is 3.31mm2.• Torque spec for terminals is 0.5 Nm.• Use copper wire rated to 90°C or above. |
Related manuals for red lion RAM 9000
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved