OneStart

Menu

kala Starter 1080 User Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Contents
  1. Table Of Contents
  2. Conformity Declaration & Warranty
  3. The reception of your laminator
  4. Caution when installing the machine
  5. Components of the laminator, Control board
  6. Control board
  7. Adjustments and recommendations
  8. Roller pressure adjustment
  9. Film tension adjustment
  10. Switching off the machine
  11. Application
  12. Use of application tape
  13. Mounting onto rigid boards
  14. Options
  15. Pressure adjustment
  16. Maintenance and Safety
  17. Technical data
  18. Lamination incidents
  19. Wiring diagram
kala Starter 1080 User Manual Manual pdf 23 page image
USER MANUAL STARTER23TRANSLATED FROM ORIGINAL VERSION: EDITION 16. APPLICATIONSD - Optional stand :7. ADJUSTMENTS7.1 Recommandations for pressure adjustmentSingle side lamination, adhesive mounting :Paper, vinyl, polyesterColour of the LED pressure gauge indicator based on the print width.Mounting onto rigid boards : Foam board, PVC…Colour of the LED pressure gauge indicator based on the board width.7.2 Speed adjustment recommendationSpeed should be adjusted depending on your work and experience. However, it is recommended tostart with a lower speed when feeding the prints through the roller to make sure the operation is fineand then increase the speed based on your application.- : Medium pressure : Print width below 2/3rd of the total width of the machine.- : Full pressure : Print width over 2/3rd of the total width of the machine.- : Low pressure : width of the board below ½ of the total width of the machine.- or : Medium to full pressure : width of the board above ½ of the total width of the machine.Machine can be installed onto theoptional stand with castors.Electrical print rewinder (§B above) andfilm reels holder (§C above) can beadded to it.To mount it onto the machine,please refer to the assemblyinstruction delivered with the kit.-
/ 27
Related manuals for kala Starter 1080
kala Sirocco 1080 User Manual first page preview
kala Sirocco 1080 User Manual
kala Mistral 1650 User Manual first page preview
kala Mistral 1650 User Manual
This manual is suitable for:
Starter 1080Starter 1400Starter 1600
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved