56-101-01175 Revision I Page | 75CHAPTER 5: RECEIVING, SHIPPING, AND STORAGE1. RECEIVINGNo special unpacking procedures are necessary. It is recommended that the factory-shipping container and packing materials be retained should it become necessary to re-ship the Test Set for a variety of reasons, including O.E.M. recertification.It is also recommended that the Test Set undergoes a leak check upon receipt and its carryingcase should be carefully inspected for damage. If the Test Set has an excessive leak or isdamaged, immediately notify the carrier and the manufacturer.2. SHIPPINGA. It is recommended that the factory-shipping container and packing materials beretained should it become necessary to re-ship the Test Set for a variety of reasons,including O.E.M. recertification.B. Ensure the unit is Safe at Ground.C. Disconnect hoses from the Static and Pitot ports and install AN4 caps on each.D. Ensure unit is powered off. Disconnect the power cable and store in lid pouch.E. Reaffix the lid if previously removed.F. Use standard delicate electronic equipment packaging procedures when packing theTest Set for reshipment.3. STORAGEA. Place a four-ounce bag of desiccant inside the case.B. Close and latch the cover.C. Store in a cool dry place.Note: Should the Test Set become exposed to moisture or very high humidity, dry it assoon as possible and temporarily store it in a dehumidified area.
