barfield DPS1000 User Instruction Manual

Also see for DPS1000: User instruction manual User instruction manual User instruction manual

Contents

barfield DPS1000 User Instruction Manual Manual pdf 34 page image

56-101-01175 Revision I Page | 34which will cause the Target keypad to be displayed for user entry. For this examplethe ALT touch zone was selected.9. While in Leak Measure mode, the touch screen is not active for any of the 4-parameters. Only the right half side of the screen, the Leak Measure mode and theControl mode soft-keys are active.Figure 23 Target Value Keypad ScreenB. Display Setup – Configuring display formatThe Display Setup allows the user to configure the display as a 2 or 4-parameter format.While operating in Aeronautical mode for example, the 4-parameter format will allowALT, ROC, CAS and MACH or ALT, ROC, CAS, and RtCAS to be displayed. While inControl mode, Target values can be assigned to ALL 4 parameters by simply touchingthe screen on each of the 2 or 4-parameter displayed areas.Figure 24 Display Setup: 4-Parameter Format