Zodiac VORTEX-PRO VX40 Owner's Manual

Also see for VORTEX-PRO VX40: Owner's manual

Contents

Zodiac VORTEX-PRO VX40 Owner's Manual Manual pdf 19 page image

3. To install a new brush matt, position thenew brush matt on the roller with the bristlesfacing downwards (Figure 32).3Figure 32. Install the New Brush4. Thread each tab into the slot provided andgently feed it through until the heel comes outat the other side of the slot (Figure 33).4Figure 33. Pull Tabs Through Each Slot5. Use scissors to cut the tabs at the guides, asshown in Figure 34.Figure 34. Cut Tabs6. Repeat this procedure to replace the secondbrush matt.6.4 Replacing the Tyres1. Pull on the inside of the old tyre to remove thetyre lip from the wheel (Figure 35).1Figure 35. Pull the Old Tyre Over the Wheel2. Remove the old tyre (Figure 36).2Figure 36. Remove the Old Tyre3. To replace the tyre, position the tyre on thewheel making sure to orient the tyre so that theword INSIDE is toward the body of the cleaner(Figure 37).19H0516700_REV A