Ziton zp1-f Series Operation Manual

Also see for zp1-f Series: Quick operation guide Quick installation guide Installation manual

Contents

Ziton zp1-f Series Operation Manual Manual pdf 17 page image

ZP1-F Series Operation Manual 13Control panel operationUser levelsFor your safety, access to some features of this product are restricted by userlevels. The access privileges of each user level are described below.Public userThe public user level is the default user level.This level allows basic operational tasks to respond to fire alarms and/or faults atthe control panel. No password is required.See “Public user level operation” below for more information.Operator userThe operator user level allows additional operating tasks that command thesystem or perform maintenance actions. It is reserved for authorized users whohave been trained to operate the control panel.The default password for the operator/maintenance user is 2222.See “Operator user level operation” on page 16 for more information.This is a restricted user level protected by password security. To enter theoperator user level, enter the corresponding password using the numeric keypad,and then press Enter.A long beep and a steady Reset LED indicate that the correct password wasentered and that the operator user level is active. Three short beepsaccompanied by a flashing General Fault LED indicate that an incorrectpassword was entered.The control panel automatically exits the operator user level and reverts to thepublic user level after 5 minutes if no button is pressed.Note: The control panel is available with an access key option. The key switch islocated on the panel cover. With this option, either the key or the password canbe used to enter the operator user level.Public user level operationPublic user level operations are those that can be performed by any user. Nopassword is required to perform tasks at this level.Public user level operation lets you:• Acknowledge a system event and silence the control panel buzzer• Cancel an active sounder (or evacuation for NBN S 21-100) delay• Cancel an active fire routing (or warning for NBN S 21-100) delay• Perform a control panel LED and buzzer test• Display local indications only (for control panels with repeater functionality)