OneStart

Menu

ZinWave 2700 User Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Page 28 preview
Page 29 preview
Page 30 preview
Page 31 preview
Contents
  1. About this guide
  2. Table Of Contents
  3. Table Of Contents
  4. Get Ready
  5. Installing the Software
  6. Verifying your software installation
  7. Installing the Hardware
  8. Set Up Your System
  9. How to connect the Hub
  10. How to connect the Antenna Unit
  11. Use Your System
  12. Command Line Interface
  13. Starting the software
  14. Configuring devices
  15. Alarms
  16. Get results fast
  17. Get Assistance, if You Need It
  18. Returning the System for Service
  19. A Safety and Regulatory Information
  20. Installation, Use, and Storage
  21. B Connection Panels and LED Indicators
  22. C System Information
  23. System specifications
  24. D Glossary of terms
ZinWave 2700 User Manual Manual pdf 14 page image
How to connect Antenna Units (AU) to the Hub (HU)CAUTION Electrostatic discharge (ESD) preventative measures (i.e. wrist straps, useof ESD protective bags) should be taken when storing, transporting and handlingSFPs as voltages in excess of 50V can cause damage to the device.Hold the SFPs by the metal body and insert it into the designated HU and AU opticalslots. An audible click can be heard when the SFP is fully latched. Ensure that thede-latch bail is in the upright position.Figure 15Removal of the SFP is achieved by extending the de-latch bail and pulling it awayfrom the unit.Figure 16Remove the protective end caps and connect the patch cord between the SFP on theHU (Figure 11) and the local end of the Installed Fibre and between the remote endof the Installed Fibre and the SFP on the AU. (Figure 12)The optical connectors arekeyed and care must be taken when inserting them.Figure 17 Figure 18NOTE Using patch cords other than those specified by ZinWave can affect theoverall performance of the system.Issue 3 Page 14 of 31 15/11/2006
/ 31
Related manuals for ZinWave 2700
ZinWave 2700 DAS Installation And Technical Manual first page preview
ZinWave 2700 DAS Installation And Technical Manual
This manual is suitable for:
2700
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved