START-UPCarl Zeiss Attachment of binocular (photo)tube Axiovert 2002-6 B 40-080 e 03/012.2 Attachment of binocular (photo)tubeAll the binocular tubes listed in the microscopeconfiguration can be attached to the Axiovert 200and Axiovert 200 M as described below.Proceed as follows to attach a tube for the firsttime, or to replace a tube:• Loosen hexagonal screw (2-2/2) using the SW3ball-headed screwdriver. If a tube is to bereplaced, hold it and remove it in forwarddirection.• Remove the dust cap from the tube lens of thetube to be attached.• Insert dovetail of the binocular tube (2-2/1)into the stand mount (2-2/3), align it with thestand and tighten hexagonal screw (2-2/2)using the ball-headed screwdriver.2.2.1 Inserting the eyepieces and thecentering telescope• Remove both dust protection caps (2-3/1 and4) from the binocular tube.• Remove both eyepieces (2-3/2) from the casesand insert them in the binocular tube until stop.• The centering telescope (2-3/3), which is usedto view the aperture and phase stops and tocenter the phase stops, can be inserted in oneof the tubes instead of an eyepiece. Thevariable eyelens permits focusing on thesestops. The eyepieces W-PL 10x/23 Br. foc. can be attached to all tubes.Fig. 2-2 Attachment of binocular tubeFig. 2-3 Inserting the eyepieces
