Modules & Options7 - 12 PC Camera Module7PC Camera Driver Installation1. Make sure the module is powered on (click Cancel if you see a “NewHardware Found” message) , and then insert the Device Drivers & Utilities+ User’s Manual CD-ROM into the CD/DVD drive.2. Click 10.Install Camera Driver > Yes.3. Choose the language you prefer and click Next.4. Click Next > Install.5. Click Finish to restart the computer.6. Setup your Windows Color and Appearance to Windows Aero before run-ning the BisonCap application (see “Color Scheme Setup” on page 7 - 11).7. Run the BisonCap application program from the BisonCam shortcut on thedesktop, or from the BisonCam item in the Start > Programs/All Pro-grams menu (if the hardware is turned off use the Fn + F10 key combina-tion to turn it on again).Model A & B Computers Only8. You can use the application button to run the BisonCap application ifyou have installed the hot key driver (see “Hot Key Utility (Model C Com-puters)” on page 4 - 6).9. A Snapshot folder will be placed on the desktop to record still picturestaken with using the application button (see “PC Camera Hot Key But-tons” on page 7 - 17).PC Camera PowerErrorThe BisonCap applica-tion may not recognizethat the camera moduleis powered on if youmanually put the sys-tem into Sleep or Hiber-nate, and then resume,when the BisonCap ap-plication is still running.Before putting the sys-tem into a power-savingstate close the Bison-Cap application. If youresume from a power-saving state and see anerror message dis-played by the BisonCapapplication, simply quitthe application and run itagain.
