ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at 23ZI-HDR40V-AKKU14 SAFETY14.1 Intended UseThe machine must only be used for its intended purpose! Any other use is deemed to be a case ofmisuse.To use the machine properly you must also observe and follow all safety regulations, the assemblyinstructions, operating and maintenance instructions lay down in this manual.All people who use and service the machine have to be acquainted with this manual and must beinformed about the machine's potential hazards.It is also imperative to observe the accident prevention regulations in force in your area.The same applies for the general rules of occupational health and safety.The machine is used for:Clean vehicles, machines, buildings, facades, etc. in the private sector.This machine is not intended for use by persons (including children) with reduced physical, sensoryor mental capabilities, or lack of experience and knowledge, unless they have been givensupervision or instruction concerning use of the machine by a person responsible for their safety.Never allow children or people unfamiliar with these instructions to use the machine. Supervisechildren. This will ensure that children do not play with the machine.Any manipulation of the machine or its parts is a misuse, in this case ZIPPER-MASCHINEN andits sales partners cannot be made liable for ANY direct or indirect damage.W A R N I N G▪ Before using read the user instructions of accessories (charger, battery)▪ Never use the machine with defective or without mounted guard▪ The removal or modification of the safety components may result in damage toequipment and serious injury!HIGHEST RISK OF INJURY!Ambient conditionsThe machine may be operated:temperature +1°С to +40°The machine shall not be operated in areas exposed to increased fire or explosion hazard.Prohibited use:• The operation of the machine outside the stated technical limits described in this manual is forbidden.• The operation of the machine without provided protective devices is prohibited• The use of the machine not being suitable for the use of the machine and not being certified isforbidden• The use of the machine not according with the required dimensions is forbidden.• Any manipulation of the machine and parts is forbidden.• The use of the machine for any purposes other than described in this user-manual is forbidden.• It is not allowed to leave the immediate work area during the work is being performed.