OneStart

Menu

Z-Com ZMAX-8210-E User Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Page 28 preview
Page 29 preview
Page 30 preview
Page 31 preview
Page 32 preview
Page 33 preview
Page 34 preview
Page 35 preview
Page 36 preview
Page 37 preview
Page 38 preview
Page 39 preview
Page 40 preview
Page 41 preview
Page 42 preview
Page 43 preview
Page 44 preview
Page 45 preview
Page 46 preview
Page 47 preview
Page 48 preview
Page 49 preview
Contents
  1. about this manual
  2. Table Of Contents
  3. Table Of Contents
  4. Table Of Contents
  5. Chapter 1 Introduction
  6. Key Feature
  7. Figure 3 Wireless Point-to-Point Outdoors
  8. Figure 4 Wireless Point-to-multipoint Outdoors
  9. Chapter 2 Basic Installation
  10. antenna installation
  11. Chapter 3 Basic Settings
  12. ZMAX
  13. Figure 7 ZMAX-8210 General Information
  14. IP addres
  15. Figure 10 ZMAX-8210 Wireless Parameters
  16. Figure 11 Build the Infrastructure with WiMAX Base Station
  17. Chapter 4 Advanced Configuration
  18. Figure 13 Wireless Router Mode
  19. DHCP S ERVER
  20. HTTP R EDIRECT
  21. Figure 18 HTTP Redirect
  22. Chapter 5 Management
  23. Figure 20 ZMAX-8210 Statistics Information
  24. Figure 23 Retrieve and Backup Settings
  25. Figure 24 ZMAX-8210 Default Button
  26. Figure 26 Putty Settings
  27. Figure 27 Putty settings 2
  28. Chapter 6 Troubleshooting
  29. Figure 30 ZMAX-8210 Wireless Network Connection Properties
  30. Figure 31 ZMAX-8210 Ping
  31. Appendix A Specifications
  32. Table 3 ZMAX-8210-E Spec
  33. Appendix B Technical Terms
  34. Appendix C ASCII
  35. Appendix D SSH Settings
Z-Com ZMAX-8210-E User Manual Manual pdf 18 page image
If you fail to obtain IP address for the ZMAX-8210, the CPE will turn to the clientaddress for use.Wireless ParametersOpening“Radio Settings can lead you to the ZMAX-8210 wireless parameters. You can set what youdesire.Figure 10 ZMAX-8210 Wireless ParametersBase Station ID：This field allows you to enter the Base Station ID you want to connect, to establisha tie between this CPE and the Base Station.Duplex Mode：This field allows you to have the options of TDD and HFDD modes.Under the Duplex Mode, you are required to keep the consistency in setting betweenthe ZMAX-8210 and the Base station.Center Frequency：This field helps you to scan the center frequency that the linked device performsand shows the frequency in this field.CP Size：This field displays the ratio of hardware MTU (maximum transmission unit) beforerotating this device.Bandwidth：This field provides the bandwidth when this device is undertaking tasks. You can gettwo options-- 3.5MHz and7MHz.Note：Note：The bandwidth shall be in the complete accord between the ZMAX-8210 and theBase Station connected.Frame Length：This field displays the frame length that the ZMAX-8210 can obtain from otherChapter 3 Basic Settings - 12 -
/ 49
This manual is suitable for:
ZMAX-8210-EZMAX-8210-I
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved