Menu
Xtender XTS 900-12 User Manual
                                                        | |
Contents
| 
Studer Innotec SAXtenderUser manual V4.6.0 62.2 CONVENTIONSThis symbol is used to indicate the presence of a dangerous voltage that is sufficient toconstitute a risk of electric shock.This symbol is used to indicate a risk of material damage.This symbol is used to indicate information that is important or which serves to optimise yoursystem.This symbol placed on the product indicates that its surfaces may reach temperatureshigher than 60°C.This symbol placed on the product indicates that its use must follow the instructions in theuser’s manual.All values mentioned hereafter, followed by a parameter number indicate that this value may bemodified using the RCC-02/-03 remote control.In general, the default values are not mentioned and are replaced by a parameter number in thefollowing format: {xxxx}. The default values for this parameter are specified in the defaults parametertable, p. 47.All parameter values modified by the operator or installer must be transferred into the sametable. If a parameter not appearing in the list (advanced parameters) has been modifiedby an authorised person with technical knowledge, they will indicate the number of themodified parameter(s), the specifications of the parameter(s) and the new value set, at theend of the same table.All figures and letters indicated in brackets or in square brackets refer to items that can be found inthe separate manual "Appendix to the installation and operating instructions" supplied with thedevice. In this appendix, these figures and letters are encircled. The figures in brackets refer to elements belonging to the Xtender. The uppercase letters in brackets refer to AC cabling elements. The lowercase letters in brackets refer to battery cabling elements. The comments on figures and items of the appendix are given starting on p. 42.2.3 QUALITY AND WARRANTYDuring the production and assembly of the Xtender, each unit undergoes several checks and tests.These are carried out with strict adherence to the established procedures. Each Xtender has a serialnumber allowing complete follow-up on the checks, according to the particular data for eachdevice. For this reason it is very important never to remove the type plate (appendix 1 – fig. 3b) whichshows the serial number. The manufacture, assembly and tests for each Xtender are carried out intheir entirety by our factory in Sion (CH). The warranty for this equipment depends upon the strictapplication of the instructions appearing in this manual. |
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved