Xerox X2 User Manual

Also see for X2: User guide System introduction

Contents

Xerox X2 User Manual Manual pdf 39 page image

Operations 27Printing surfaceUsing the take-up roller (con’t)Setup the take-up assembly (con’t)3. Set the FLANGE on the plastic roller bearing onthe right side.4. Set the left FLANGE on the plastic roller bearing.If you need to adjust the length, do steps 1 and 2again. (Note that the end caps for the take-uproller are black versus the green caps for themedia roller. Use these for optimumperformance.)5. At the operations panel, enable the take-up roll.a. Press the Menu button (top button) to entermenu mode.b. Press the button associated with the Setmenu option.c. Press the left arrow button 4 times to displaythe Winding direction option.d. Set to the desired direction: Image In orImage Out.Starting the take-up roller1. When the printed media passes completely overthe platen and emerges out the exit chute, guidethe media over or under the take-up roll andtape it to the roll.2. Monitor the media until it has rolled once aroundthe take-up roll. From this point on, the mediawill wind up automatically.Operating the printer from RIP softwareInstructions for operating the printer using the host computer’s digitalfront end (DFE) program are covered in associated DFE softwaremanuals or release notes.