Xerox WorkCentre 77 Series Reference Manual

Also see for WorkCentre 77 Series: Configuration guide Manual

Xerox WorkCentre 77 Series Reference Manual Manual pdf 1 page image

September 17, 2010dc10cc0469PDL Reference Guide for theXerox WorkCentre 77xx SeriesCustomer TipAccessing Extended FeaturesOverviewThis document describes how to access the extended features of the WorkCentre 77xx Series in environments for whichXerox does not make a custom driver.Note: Some of the commands and syntax used in this document requires familiarity with either PostScript (PS) or PrinterCommand Language (PCL).This document provides the Printer Description Language (PDL) commands and syntax for each feature. The followingtables are also included: features supported by the WorkCentre 77xx Series commands to use in a PCL print job commands to use in a PS print jobThis document is not intended as a PS or PCL reference manual, but a guide for using the extended features in PS, PCL orASCII print jobs.Using this Guide1. Refer to the Feature List for the feature you wish to implement. Select the page number to jump to that page.2. Follow the syntax listed for the command you selected. Read the “Dependencies/Caveats” section. You can accessfeatures using several methods: PCL or PS commands PJL SET commands Xerox specific COMMENT command.Feature ListingPCL and ASCII print jobs can use PJL commands or PCL commands to access the attributes of the device. If there is morethan one method listed to access a specific feature, determine the best method for your application and use that method.PostScript print jobs can use Document Structuring Commands (DSC) or PS commands. If there is more than one methodlisted to access a specific feature, determine the best method for your application and use that method.For this document, both PJL COMMENT and DSC are referred to as Comment commands.dc10cc0465Customer Support Page 1