Loading Paper in the TraysXerox WorkCentre 5016/5020 User Guide433. Load paper neatly and tightly againstthe left corner of the tray with the sideto be printed facing up.Important • Do not load paper above themaximum fill line. It may causepaper jams or may lead to machinemalfunctions.4. Adjust the three paper guides to justtouch the edges of the paper, and alignthe arrow on the right paper guide withthe appropriate paper size marking onthe label.Important • If you do not adjust the paperguides correctly, it may result in apaper jam.Note • If loading a relatively thin stack ofpaper in the tray, when tightlyadjusting the right paper guide upagainst the edge of the paper, the stack of paper can be warped. This will not result in apaper jam as long as the paper guide arrow is correctly aligned with the appropriatepaper size marking on the label.5. Push Tray 1 gently back into position.Loading Paper in Tray 2If the machine runs out of paper in Tray 2 during copying or printing, the Tray 2 indicatoron the Machine Diagram (mimic) flashes, and the error code appears in the Display.Copying or printing automatically resumes when a sufficient amount of paper is loadedin Tray 2.The following procedure describes how to load paper in Tray 2.Important • Paper Tray 2 is an optional accessory that can be used as Tray 2.• Before loading paper in the tray, fan the edges. This separates any sheets of paper thatare stuck together, and reduces the possibility of paper jams.1. Pull out Tray 2 towards you.Important • While the machine processes ajob, do not pull out the tray in use.
